Plarn Hair Barrette

Free Recycled Crochet Pattern

Plarn Hair Barrette
Plarn Hair Barrette
Print Friendly and PDF

Thank you to all those who let me know about the printing problems. I think the "Print Friendly" code is working again. Not sure what the problem was but it should be working now. Let me know if you still run into issues.

And you can still right click and select print. It will give you a clean ad-free layout of the page. After you select print you can change the destination in the top left and save it as a PDF, fax it, or send it to your Google Drive. :)


How to make plarn

Material: 1" wide plarn, looped together. I used about half of a garbage bag.
Hook size: K/10.5-6.50MM
Finished Size: 3 by 3.5 inches.

Rnd 1: Ch 4, 2 sc in second ch from hook, sc in next ch, 4 sc in next ch. Working in back loops sc in next ch, 2 sc in next ch. Place stitch marker in last st made. (10 sc)

Rnd 2: 2 sc in next 2 sts, sc in next st, 2 sc in next 4 sts, sc in next st, 2 sc in next 2 sts. Place stitch marker in last st made. (18 sts.)

Rnd 3: 2 sc in next 2 sts, sc in next 5 sts, 2 sc in next 4 sts, sc in next 5 sts, 2 sc in next 2 sts, (26 sts)

Rnd 4: Fpsc around next 2 sts of round 3, fpsc around next st of round 2 and around each stitch of round 2.

Rnd 5: Fpsc around each st of rnd 1. Fpsc around 3 beg chs, sl st into same ch as last fpsc.

Fasten off leaving enough plarn needed to sew onto any barrette of choice. Simply pull the end of the plarn through to the wrong side of work and sew onto barrette.

Leave Your Comments Below